Wine Guardian WG15 Installation, Operation And Maintenance Manual page 25

Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
2. Remove the back plate of the controller and
mark the mounting points at the desired location.
(Fig. 2)
a) Mark the location of the communication
cable connection as this area will require
sufficient clearance for instance, a 3.8mm
hole in the wall for flush mounting of the
back plate. (Fig. 3)
3. Drill two 2cm holes and insert anchors
(provided) within the mounting surface. Anchors
may not be required if securing to a wall stud or
racking system.
4. Plug in the communication cable to the back of
the Remote Interface Controller backing plate.
(Fig. 4)
a) Attach backing plate to wall using the two
screws provided with the system. (Fig. 5)
5. Re-install plastic face plate on to backing
plate. (Fig. 6)
25