Electrical Plug Configuration; Installing The Thermostat And Control Wiring; Removing The Wires For Installation (If Necessary) - Wine Guardian 24S025 User Manual

DO NOT:
√ DO NOT MODIFY THE PLUGS IN ANY WAY!
√ Do not use extension cords.
The electrical power supply must be either 115 volt or 230 volt AC 1 phase 60 cycle,
depending on the model of the unit, and cannot vary more than +/- 4% or damage
Plug the unit into the wall outlet. Gently pull on the plug to make sure it is tight.

Electrical Plug Configuration

Installing the Thermostat and Control Wiring

Each Wine Guardian unit comes with a thermostat and 25' of wiring. It is wired at the factory
for testing prior to shipment. See start-up instructions in the thermostat guide for installation
and operation of the thermostat.
Keep the thermostat guide in a folder along with the Wine Guardian Manual for future refer-
ence.

Removing the Wires for Installation (if necessary)

1) Note the color coding of the wires before removing
2) Using the proper screwdriver, loosen the screws and pull the wire free.
26
IMPORTANT
may occur to the unit.
Note