Use As Power-Supply Unit For S-0808 (Thru) - Roland S-4000M Owner's Manual

Use as Power-supply Unit for S-0808 (THRU)

Make sure the S-4000M is powered off and set the [MODE] switch to [THRU].
fig.thru-SW.eps
Setting the S-4000M to this mode internally connnects REAC port 1/2 and 3/4. So this configures two S-0808 systems and makes
the S-4000M function as a power source of REAC EMBEDDED POWER.
* No REAC communication can be performed between the two systems.
* In the figure shown below, 1 through 4 refer to the REAC port numbers.
fig.thru-image.eps
S-0808 System #1
When the S-4000M is set to this mode, the REAC port A is inactive.
When the S-4000M is set to this mode, the REMOTE connector is inactive. To control preamps, connect one of followings to
REMOTE connectors of each S-0808 system (choose Master or Slave) .
• S-4000R remote controller (as above)
• Computer running dedicated remote control software (S-4000 RCS)
When the S-4000M is set to this mode, do not connect another S-4000M unit to REAC port A or any of the REAC ports from 1 to 4
on the first S-4000M.
S-4000R
EXAMPLE
Master
Slave
1 2 3
Pair Pair
S-0808 System #2
4
Setting the Operation Mode
S-4000R
Master
Slave
11