Removing and Replacing the Digital Board
To replace the digital board you need:
•
Digital board (P/N A060012-01 (2.4 GHz), or A060012-02 (915 MHz))
You need this tool:
•
Torque driver with a #10 Torx bit
To remove the digital board
1. Open the 1555 and disconnect the upper case assembly as described on page 2-12.
2. Disconnect the 8-pin flex cable from its connector on the rear of the scan engine.
3. Disconnect the 12-pin flex cable from its connector on the digital board.
4. Remove the Torx screw holding the digital board on the RF board assembly.
Replacing Parts in the 1555
2.4 GHz
shown here
8-pin flex cable
12-pin flex cable
2
2-15