Intermec Sabre 1555 RFID Service Manual page 14

Sabre 1555 RFID and Bar Code Reader Service Manual
1555 Troubleshooting Guide (continued)
1-6
Problem Steps to Follow
Low RFID throughput. 1. Open the case as described on page 2-12.
2. Make sure the 25-pin flex cable from the RF board to the digital
3. Check all flex cables for routing and placement.
4. Replace the digital board as described on page 2-15.
For 2.4 GHz versions manufactured before September 2001,
check the digital board for the correct revision (Rev. C printed on
board OR large inductor mounted on board surface during
rework).
For 2.4 GHz versions manufactured in or after September 2001,
and for all 915 MHz versions, continue with the next step.
board is seated properly.
Large
inductor