Intermec Sabre 1555 RFID Service Manual page 21

Handle PCB Flex Cable Installation
3. Install the 8-pin flex cable in its connector on the new handle PCB. The contacts
4. Install the 12-pin flex cable in its connector. The contacts must face away from the
5. Install the 10-pin flex cable in its connector. The contacts must face the PCB. Be
6. Insert the edge of the handle PCB into the locating slot in the lower case assembly.
8-pin
connector
Heatsink end
of 1555
must face the PCB. Be sure the flex cable is seated correctly and latch the
connector.
PCB. Be sure the flex cable is seated correctly.
sure the flex cable is seated correctly and latch the connector.
Be careful not to stress the flex cables as you position the board. Route the flex
cables below the narrow edge of the handle PCB.
Replacing Parts in the 1555
12-pin
connector
Locating slot
2
10-pin
connector
PCB brace
2-7