Changing The Interface Cable; Verifying That Your Scanner Supports The Interface; Removing And Replacing The Scanner Interface Cable - Intermec SR61T2D Programmer's Reference Manual

Changing the Interface Cable

Verifying that Your Scanner Supports the Interface

Removing and Replacing the Scanner Interface Cable

SR60 Scanner Programmer's Reference Manual
Chapter 1 — Learning About Programming the SR60 Scanner
Note: The part numbers for the keyboard wedge cables available
from Intermec are listed in the "PC Keyboard Interfaces and
Cables Supported " table on page 20.
If you need to move the scanner to a host terminal of a different
interface type, you simply connect the scanner to the new host
using the appropriate interface cable. The scanner automatically
changes to the interface functions specific to that cable.
You must make sure that your SR60 scanner supports the
interface you want to change to. The following list indicates the
interfaces each SR60 scanner supports:
• SR60 scanner with C/N SR60BX01 (XLR) or
C/N SR60BL01 (SR) supports the Wand Emulation,
RS-232, and Keyboard Wedge interfaces.
• SR60 scanner with C/N SR60BX02 (XLR) or
C/N SR60BL02 (SR) supports the USB interface.
• SR60 scanner with C/N SR60BX03 (XLR) supports the
Laser Emulation interface.
You can find the scanner C/N on the label above the trigger.
You can change your scanner interface cable by following these
instructions.
To change the scanner interface cable
1 Loosen the screw at the bottom of the handle. This screw is
captive and does not come all the way out.
Do not try to pull the end cap off, as this may damage the
scanner.
2 Swing the forked cable retainer clear of the square hole in the
end cap and rotate away from the cable.
9