Creating A Wand Emulation Connection; Removing A Cable; Configuring Your Sr30 Parameters - Intermec SR30 User Manual

Creating a Wand Emulation Connection

1 Make sure that you have the wand emulation cable
(
P/N 236-163-xxx)
2 Turn off your host device.
3 Connect the cable to your SR30 and host device.
4 Turn on your host device.

Removing a Cable

Configuring Your SR30 Parameters

After you connect your SR30 to a host device, you may need to
configure your SR30 to communicate properly with the host
device. This section contains bar codes to configure your SR30:
• for an International keyboard.
• serial parameters.
To configure additional SR30 settings, see EasySet version
5.4.4.0 or later. EasySet is available on the CD that ships with the
SR30 or from the Intermec web site at www.intermec.com.
SR30 Handheld Scanner User's Guide
Chapter 2 — Connecting and Configuring the SR30
.
Straightened
paper clip
To host device
9