Getting Started Guide Sabre 1555 RFID & Bar Code Reader Guía de Iniciación Guide de Démarrage Anleitung für Einsteiger P/N 3-740049-01 Guida Introduttiva Guia de Iniciação...
Page 2
Introduction Use this Getting Started Guide to set up the Sabre 1555 RFID and Bar Code Reader for most terminal connections and symbologies. If necessary, use the EasySet setup software for additional configuration possibilities and terminal connections. Basic setup Configuración básica...
Page 3
Connect scanner cable Scanner cable depends on your terminal Version Standard Version Cables Accessories...
Page 4
Ë Connect cable Direct RS-232 C cable (1555 57D) P/N 3-614032-00 Ì Ì Scanner power ON Í Í System power ON Î Switch to Barcode Read Mode (PDT version shown) Standard version -- press mode button, read display PDT version -- press mode button + pull trigger, read display Ï...
Page 5
Ð Customize parameters (optional) (*) = default value 9600 baud 19200 baud (*) 7 data bits (*) 8 data bits Even parity (*) Odd parity No parity Postamble = Carriage Return + Line Feed (*) Postamble = Carriage Return Postamble = none...
Page 6
Ê System power OFF Ë Ë Connect cable Ì Ì Scanner power ON Í Í System power ON Î Switch to Barcode Read Mode (PDT version shown) Standard version -- press mode button, read display PDT version -- press mode button + pull trigger, read display Ï...
Page 7
Ð Customize parameters (optional) (*) = default value 9600 baud 19200 baud (*) 7 data bits (*) 8 data bits Even parity (*) Odd parity No parity Postamble = Carriage Return + Line Feed (*) Postamble = Carriage Return Postamble = none...
Default setup Full setup with EasySet Ê System power OFF Ë Connect RS-232 C cable Direct RS-232 C cable Ì Scanner power ON Í System power ON Î Start EasySet software Power supply P/N 070826 (1555 57D) P/N 3-614032-00 EasySet...
Laser warnings The Sabre 1555 has a maximum laser output of 1mW at 630-680 nm and complies with the following safety standards: USA: CDRH - Class II Laser Product (CFR 21 Subpart J) IEC 825-1 EN 60825-1 - Class 2 Laser Product Fix these warning labels onto the product if they are not already present.
EMC Directive 89/336/EEC as amended by 92/31/EEC and by the Low Voltage Directive 73/23/EEC as amended by 93/68/EEC: EN55022, EN50082-2, EN60950 This device is TÜV GS licensed (EN 60950 and EN 60825-1) for safety when powered by a host system or by the following external Intermec power supply: Catalog No. and P/N 070826, 90-264 VAC, 47-63 Hz.