Intermec Sabre 1555 RFID Service Manual page 27

5. Lift the RF board/antenna assembly out of the lower shell.
6. Pull the piezo connector (on the end of the twisted pair) from the connector on the
handle PCB. The upper case assembly is now disconnected from the 1555.
7. Place the RF board assembly in the lower shell.
You are now ready to replace other parts as listed in the next table.
To Replace
Piezo assembly
Digital board
Scan engine
Shield and chassis assembly (915 MHz), or
Antenna assembly (2.4 GHz)
Upper case assembly
Replacing Parts in the 1555
See Page
2-14
2-17
2-20
2-23
2-29
2
2-13