Intermec Sabre 1555 RFID Service Manual page 46

Sabre 1555 RFID and Bar Code Reader Service Manual
7. Place a small piece of Kapton tape over the 8-pin connector and flex cable to secure
8. Slide the excess 8-pin flex cable into the gap between the RF board and the digital
9. Insert the 10-pin flex cable into the connector on the keyboard PCB. The flex cable
2-32
them.
board. Fold the excess 12-pin flex cable over the top of the digital board.
contacts should face the center of the 1555.
8-pin flex cable
installed on back
of scan engine
12-pin flex cable
installed and
folded over
10-pin flex cable
Contacts to this
side of connector