10.11.2 Coder Parameters; 10.11.3 Fax And Modem Parameters; Table 10-32: Coder Parameters; Table 10-33: Fax And Modem Parameters - AudioCodes MediaPack MP-124 User Manual

Parameter
[ECNLPMode]
[EchoCancellerAggressiveNLP] Enables or disables the Aggressive NLP at the first 0.5 second of
[RTPSIDCoeffNum]

10.11.2 Coder Parameters

The coder parameters are described in the table below.
Parameter
Web: DSP Version Template
Number
EMS: Version Template Number
[DSPVersionTemplateNumber]

10.11.3 Fax and Modem Parameters

The fax and modem parameters are described in the table below.
Parameter
Web: Fax Transport Mode
EMS: Transport Mode
[FaxTransportMode]
SIP User's Manual
Defines the echo cancellation Non-Linear Processing (NLP)
mode.
[0] = NLP adapts according to echo changes (default).
[1] = Disables NLP.
[2] = Silence output NLP.
Note: This parameter can also be configured per Tel Profile,
using the TelProfile parameter (see ''Configuring Tel Profiles'' on
page 121).
the call. When enabled, the echo is removed only in the first half
of a second of the incoming IP signal.
[0] = Disable
[1] = Enable (default)
Note: For this parameter to take effect, a device reset is required.
Determines the number of spectral coefficients added to an SID
packet being sent according to RFC 3389.
The valid values are [0] (default), [4], [6], [8] and [10].

Table 10-32: Coder Parameters

Determines the DSP template to use on the device. Each DSP
template supports specific coders, channel capacity, and features.
For the list of supported DSP templates, refer to the Release
Notes.
The default is DSP template 0.

Table 10-33: Fax and Modem Parameters

Fax transport mode used by the device.
[0] Disable = transparent mode
[1] T.38 Relay (default)
[2] Bypass
[3] Events Only
Note: This parameter is overridden by the parameter
IsFaxUsed. If the parameter IsFaxUsed is set to 1 (T.38 Relay)
or 3 (Fax Fallback), then FaxTransportMode is always set to 1
(T.38 relay).
412
MediaPack Series
Description
Description
Description
Document #: LTRT-65415