AudioCodes MediaPack MP-124 User Manual page 363

SIP User's Manual
Parameter
Web: IP Security Proposal Table
EMS: IPSec Proposal Table
[IPSecProposalTable]
Version 6.2
[ \IPsecSATable ]
For example:
IPsecSATable 1 = 0, 10.3.2.73, 0, 123456789, 0, 0, 0, 0, 28800, 3600, ;
In the above example, a single IPSec/IKE peer (10.3.2.73) is configured.
Pre-shared key authentication is selected, with the pre-shared key set to
123456789. In addition, a lifetime of 28800 seconds is selected for IKE
and a lifetime of 3600 seconds is selected for IPSec.
Notes:
Each row in the table refers to a different IP destination.
To support more than one Encryption/Authentication proposal, for
each proposal specify the relevant parameters in the Format line.
The proposal list must be contiguous.
For a detailed description of this table and to configure the table using
the Web interface, see ''Configuring IP Security Associations Table'' on
page 95.
For an explanation on using ini file table parameters, see ''Configuring
ini File Table Parameters'' on page 194.
This ini file table parameter configures up to four IKE proposal settings,
where each proposal defines an encryption algorithm, an authentication
algorithm, and a Diffie-Hellman group identifier.
[ IPsecProposalTable ]
FORMAT IPsecProposalTable_Index =
IPsecProposalTable_EncryptionAlgorithm,
IPsecProposalTable_AuthenticationAlgorithm,
IPsecProposalTable_DHGroup;
[ \IPsecProposalTable ]
For example:
IPsecProposalTable 0 = 3, 2, 1;
IPsecProposalTable 1 = 2, 2, 1;
In the example above, two proposals are defined:
Proposal 0: AES, SHA1, DH group 2
Proposal 1: 3DES, SHA1, DH group 2
Notes:
Each row in the table refers to a different IKE peer.
To support more than one Encryption / Authentication / DH Group
proposal, for each proposal specify the relevant parameters in the
Format line.
The proposal list must be contiguous.
For a detailed description of this table and to configure the table using
the Web interface, see ''Configuring IP Security Proposal Table'' on
page 94.
For an explanation on using ini file table parameters, see ''Configuring
ini File Table Parameters'' on page 194.
363
10. Configuration Parameters Reference
Description
February 2011