AudioCodes MediaPack MP-124 User Manual page 482

Parameter
Web: Reasons for Alternative Tel-to-IP Routing Table
EMS: Alt Route Cause Tel to IP
[AltRouteCauseTel2IP]
Web: Reasons for Alternative IP-to-Tel Routing Table
EMS: Alt Route Cause IP to Tel
[AltRouteCauseIP2Tel]
SIP User's Manual
This ini file table parameter configures SIP call failure reason
values received from the IP side. If an IP call is released as a
result of one of these reasons, the device attempts to locate an
alternative IP route (address) for the call in the 'Tel to IP
Routing' (if a Proxy is not used) or used as a redundant Proxy
(you need to set the parameter RedundantRoutingMode to 2).
The release reason for Tel-to-IP calls is provided in SIP 4xx,
5xx, and 6xx response codes.
The format of this parameter is as follows:
[AltRouteCauseTel2IP]
FORMAT AltRouteCauseTel2IP_Index =
AltRouteCauseTel2IP_ReleaseCause;
[\AltRouteCauseTel2IP]
For example:
AltRouteCauseTel2IP 0 = 486; (Busy Here)
AltRouteCauseTel2IP 1 = 480; (Temporarily Unavailable)
AltRouteCauseTel2IP 2 = 408; (No Response)
Notes:
This parameter can include up to 5 indices.
The reasons for alternative routing for Tel-to-IP calls apply
only when a Proxy is not used.
When there is no response to an INVITE message (after
INVITE retransmissions), the device issues an internal 408
'No Response' implicit release reason.
The device sends the call to an alternative IP route only after
the call has failed and the device has subsequently
attempted twice to establish the call unsuccessfully.
The device also plays a tone to the endpoint whenever an
alternative route is used. This tone is played for a user-
defined time (configured by the parameter
AltRoutingToneDuration).
For an explanation on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page
This ini file table parameter configures call failure reason values
received from the Tel side . If a call is released as a result of
one of these reasons, the device attempts to locate an
alternative Hunt Group for the call in the 'IP to Hunt Group
Routing Table'.
The format of this parameter is as follows:
[AltRouteCauseIP2Tel]
FORMAT AltRouteCauseIP2Tel_Index =
AltRouteCauseIP2Tel_ReleaseCause;
[\AltRouteCauseIP2Tel]
For example:
AltRouteCauseIP2Tel 0 = 3
AltRouteCauseIP2Tel 1 = 1
AltRouteCauseIP2Tel 2 = 17 (Busy Here)
Notes:
482
MediaPack Series
Description
(No Route to Destination)
(Unallocated Number)
Document #: LTRT-65415
194