5.1.15 Step 10: Configure Fax Signaling Method; 5.1.16 Step 11: Configure General Parameters - AudioCodes Mediant 1000 MSBG Installation And Configuration Manual
Enhanced media gateway and sba for microsoft lync
Hide thumbs
Also See for Mediant 1000 MSBG:
- Configuration note (60 pages) ,
- Release notes (178 pages) ,
- Cli reference manual (160 pages)
Table of Contents
Advertisement
Installation and Configuration Manual
5.1.15 Step 10: Configure Fax Signaling Method
This step defines how to configure the Fax Signaling Method to G.711 Transport for the calls
between the Media Gateway and the analog devices (ATA's and embedded Media Gateway FXS
ports).
To configure the Fax Signaling Method parameters:
1.
Open the 'SIP General Parameters' page (Configuration tab > Protocol Configuration
menu > Protocol Definition submenu > SIP General Parameters).
2.
From the FAX Signaling Method drop-down list, select 'G.711 Transport'.
3.
From Play Ringback Tone to IP drop-down list, select 'Play' to provide a ringback tone to
the analog device in case it transferred to another IP user.
5.1.16 Step 11: Configure General Parameters
Configure general parameters as described in the following sections:
Section 4.6, Defining E1/T1/BRI Trunk Settings
Section 4.7, Defining Voice Coder
Section 4.8, Define Silence Suppression, Comfort Noise and AGC
Section 4.9, Defining Early Media
SBA for Microsoft Lync
Figure 5-12: SIP General Parameters Page
109
5. Connecting Analog Devices to Lync 2010
2
3
December 2010
Advertisement
Table of Contents
