System Settings; A Camera Id Settings And Title Settings - Sanyo VCC-9000EBCP/EBSP Instruction Manual

SYSTEM SETTINGS

A Camera ID settings and title
settings
(CAMERA INFORMATION)
(See p17)
This sets the camera's address (camera ID) and title.
CAMERA ID
TITLE:0000000000000000
BACK
CAMERA ID
·TITLE:0000000000000000
BACK
B Screen display settings
(DISPLAY CONFIGURATION)
(See p18)
You can display information such as titles and setting
numbers for each menu screen on the monitor screen.
The default setting is for all displays to be "OFF". If you select
"ON", the details that have been set for a menu screen will be
displayed.
·CAMERA TITLE
AUTO PAN No.
PRESET TITLE
TOUR No.
ZOOM RATIO
DIRECTION
ZONE TITLE
·BACK
C Changing the password
(PASSWORD CHANGE) (See p19)
At the time of shipment from the factory, the password is set
to "123456" (default setting).
You can change the password if necessary.
INPUT PASSWORD:******
CONFIRM :******
PASSWORD LOCK :OFF
·BACK
(Password setting screen)
·SYSTEM INFORMATION
LENS
CAMERA
PAN/TILT PARAMETERS
AUTO MODE
PRIVACY MASK
END
: 001
: 001
:OFF
:OFF
:OFF
:OFF
:OFF
:OFF
:OFF
OLD PASSWORD: ******
·BACK
(Password change screen)
·CAMERA INFORMATION
DISPLAY CONFIGURATION
PASSWORD CHANGE
FACTORY DEFAULT
RESET
BACK
D Restoring camera settings to
their default settings
(FACTORY DEFAULT) (See p20)
The camera settings can be returned to the default settings.
A password is required in order to carry out this operation.
E Resetting settings (RESET)
(See p20)
This lets you reset camera operation so that you can redo all
operations from the beginning.
When you carry out a reset, all operations are stopped and
the settings are returned to the initial settings that were active
when the power was turned on.
- 16 -
A
B
C
D
E
English