Table of Contents
Advertisement
SETTINGS
The illustration shows the factory default settings for the switches in the camera setup section. Depending on
the camera installation location and conditions of use, it may be necessary to select other settings, without
having to make adjustments. The selected settings can be confirmed using the on-screen menu.
If adjustments are required, they can be entered using on-screen adjustment sub-menus (see
ADJUSTMENTS, page 16).
High speed electronic shutter (ES) setting
Normally, the three speed setting switches (1, 2 and 3) for the high speed electronic shutter are all set to the
OFF position. This sets the electronic shutter speed to 1/50 sec. The three switches in the camera setup
section can be set as indicated in table A to select one of the 8 speeds available.
Notes:
•
When using the high speed electronic shutter, the BLC switch must be set to the OFF position.
•
Using the high speed electronic shutter indoors with low lighting, will give darker pictures. In such a case,
add some lights to make sure the lighting is sufficient. If the lighting is very bright, pay attention to the
light angle in order to avoid or minimize the smear phenomenon effect.
•
If IRIS is set to EI (electronic iris mode), then the high speed electronic shutter speed will not correspond
to the set speed.
SYNC FL AGC
BLC
I
ES
LL ON ON
ON
AI
WB
R
ON
I
S
1
2
3
4
5
6
7
8
9 10
1
2
3 INT
OFF
OFF 7
8
OFF EI
Table A
1
1/50 sec.
1
2
3
2
1/120 sec.
1
2
3
3
1/250 sec.
1
2
3
1/500 sec.
4
1
2
3
5
1/1000 sec.
1
2
3
6
1/2000 sec.
1
2
3
7
1/4000 sec.
1
2
3
8
1/10000 sec.
1
2
3
10
English
Advertisement
Table of Contents
