Sanyo VCC-9000EBCP/EBSP Instruction Manual page 6

PART NAMES • SETTINGS • SETUP1
Setup
Refer to page 45 for details on how to drill the ceiling installation holes.
Install the main cover to the ceiling.
1
1
Make a hole in the ceiling for inserting the main cover.
2
Install the accessory clamp fitting to the top of the
main cover, and pass the cables (video output cable,
communication cable and power supply cable)
through it.
To install the clamp fitting, first screw in the main unit
A
securely, then tighten the nut
3
Pull out the three arms
adjust them to the thickness of the ceiling so that they
secure the main cover in place.
A
C
C
Connect the cables.
2
Connect all of the cables that have been passed through
the clamp fitting, pull the cables to adjust them so that
they are not loose inside the cover, and then tighten the
clamp fitting nut.
1
Video output cable: Connect to the BNC connector
that is coming out from the top of the main cover.
After making the connection, slide the insulation cover
to hide the connectors.
2
Communication cable: Connect to the terminals on
the connection board inside the main cover.
3
Power supply cable: Connect to the terminals on the
connection board inside the main cover.
Refer to "1 Connection board" in "PART NAMES" for
details on connecting to the terminals on the connection
board.
2 3
English
B
.
C
of the main cover and
B
C
1
VCC-9000EBCP/EBSP, VCC-9100EBCP/EBSP
NOTE:
• You can also connect the cables before embedding the
main cover into the ceiling. Adapt the installation procedure
in accordance with the circumstances.
• Adjust each cable so that they will not be subjected to any
outside interferences and then fix the cables in this
position.
Install the camera unit.
3
1
Connect the drop-prevention wire inside the main
cover to the hole in the base of the camera unit.
2
Align the screw holes (with slots)
camera unit with the two screws inside the main cover
so that the camera connection terminal
camera unit is directly above the camera board
and then turn the camera unit clockwise. Check that
the two screws are at the far ends of each slot, and
then securely tighten the screws.
3
Connect the camera cable.
Connect the camera connection cable from the
connection board to the camera connection terminal of
the camera unit.
Drop-prevention wire
Install the dome cover.
4
1
Install the dome cover drop-prevention wire
between the main cover and the dome cover.
2
Align the projections
B
slots in the base of the main cover, and then turn
the dome cover to the right to secure it in place.
Be sure to remove the lens cap before installing the
dome cover.
A
- 5 -
C
in the base of the
B
of the
A
C
A
in
C
on the dome cover with the
B
C
,
B
A
C