Sanyo VCC-9000EBCP/EBSP Instruction Manual page 9

PART NAMES • SETTINGS • SETUP2
Install the main cover to the bracket.
3
When installing to a wall
Wind the accessory waterproof sealing tape
the connecting part of the main cover, screw the main
cover clockwise into the bracket, and then securely
A
tighten the screw .
When installing to a ceiling
Screw the top of the main cover clockwise into the base
of the bracket, and then securely tighten the screw
NOTE: When installing the main cover to the bracket,
pull the cables to adjust them so that they are
not loose inside the cover.
4 Install the camera unit.
1
Connect the drop-prevention wire inside the main
cover to the hole in the base of the camera unit.
2
Align the screw holes (with slots)
camera unit with the two screws inside the main cover
so that the camera connection terminal
camera unit is directly above the camera board
and then turn the camera unit clockwise. Check that
the two screws are at the far ends of each slot, and
then securely tighten the screws.
3
Connect the camera cable.
Connect the camera connection cable from the
connection board to the camera connection terminal of
the camera unit.
Drop-prevention wire
B
around
A
B
A
.
A
C
in the base of the
B
of the
A
,
C
B
A
C
- 8 -
VCC-9000INCP/INSP, VCC-9100INCP/INSP
Connect the dome cover with the wire.
5
Place the connection ring of drop-prevention wire
the dome cover onto the connection screw of the main
cover, and then secure it by tightening the two nuts.
A
Install the dome cover.
6
After applying lubricating oil (accessory O-ring lube) to
A
the packing around the rim of the dome cover, fit the
dome cover into the main cover and secure it by
B
tightening the screws
from the camera before installing the dome cover.
B
A
A
. Be sure to remove the lens cap
B
English
on