Table of Contents
Advertisement
AUTOMATIC MODE SETTINGS
C Tour mode settings (TOUR)
(See p36)
This is recommended for use when certain operations
are repeated over and over.
With this mode, you move the joystick lever to memorize an
image tracing path (pattern), and the pattern is then stored
and reproduced. Setting is possible independently of any
preset positions that have also been stored.
• Up to a maximum of 1000 commands can be stored for a
single tour mode. A duration of up to a maximum of 60
seconds can be set for each command.
• Up to four tour modes can be set.
• This mode is activated using the TOUR and + buttons on
the system controller.
1
TOUR No.
TRACE
2
SHOW
3
RUN
·BACK
4
1 TOUR No.: Sets the tour mode number. Up to four
different tour modes (001 to 004) can be set.
2 TRACE: Stores the commands used for pan, tilt and
zoom operations. Up to a maximum of 60 seconds can be
stored for a single command.
3 SHOW: This lets you check the tour mode operation.
4 RUN: This starts the tour mode operation.
Tour mode 1
Tour mode 2
:
001
D Automatic pan settings
(AUTO PAN)(See p37)
This is recommended for use when monitoring a set area
at a constant speed.
You set the left and right edges of the area to be monitored,
and the camera moves back and forth between these two
points. Setting is possible independently of any preset
positions that have also been stored.
• The speed for automatic panning can be set.
• Up to four automatic pan modes can be set.
• This mode is activated using the PAN and + buttons on the
system controller.
1
AUTO PAN No.
SET LEFT LIMIT
2
SET RIGHT LIMIT
3
PAN SPEED
RUN
4
·BACK
5
1 AUTO PAN No.: This sets the automatic pan mode
number. Four modes (001 to 004) can be set.
2 SET LEFT LIMIT: This sets the left edge of the area to be
panned.
3 SET RIGHT LIMIT: This sets the right edge of the area to
be panned.
4 PAN SPEED: This sets the panning speed. The speed
can be set within the range of 001 to 255 seconds.
5 RUN: This starts the automatic pan mode operation.
(Left edge of
monitoring position)
- 32 -
:001
:
180
(Right edge of
monitoring position)
English
Advertisement
Table of Contents
