Masking Settings (Privacy Mask) - Sanyo VCC-9000EBCP/EBSP Instruction Manual

MASKING SETTINGS
(PRIVACY MASK)
Sometimes there are parts of images being monitored that need to be hidden for privacy reasons.
You can apply a privacy mask (gray pattern) to such places to hide them so that the masked areas cannot be seen by people who
are not meant to see them.
SYSTEM INFORMATION
LENS
CAMERA
PAN/TILT PARAMETERS
AUTO MODE
·PRIVACY MASK
END
Mask preset 1
1
2
·MASK No. : ·MASK No. : MASK No. : 001 001 001
SET SET SET
3
ACTIVATE : ACTIVATE : ACTIVATE : OFF OFF OFF
BACK BACK BACK
Mask presets 2 to 4 (Operating procedure is the same as for mask preset 1.)
Setting details
1 Mask preset selection (MASK No.)
You can use the joystick lever to set the privacy mask
anywhere within the area that can be monitored. One
mask can be set for each mask preset number. Up to a
maximum of four masks can be set.
The possible setting range is shown below.
Setting possible
(45˚ or higher)
Setting not possible
NOTE: The area that has been masked may become visible
at some times while the mask position is moving. If
this happens, re-adjust the mask position.
Mask preset 1
Mask preset 3
CALL PRESET 1 TO CALL PRESET 1 TO CALL PRESET 1 TO
CALL PRESET 1 TO CALL PRESET 1 TO CALL PRESET 1 TO
CONFIRM...... CONFIRM...... CONFIRM......
CONFIRM...... CONFIRM...... CONFIRM......
(Select position)
Setting possible
(45˚ or higher)
Mask preset 2
Mask preset 4
CALL PRESET 1 TO CALL PRESET 1 TO CALL PRESET 1 TO
CONFIRM...... CONFIRM...... CONFIRM......
POSITION POSITION POSITION SIZE SIZE SIZE
(Select size)
2 Mask setting (SET)
When you select "SET", the mask setting window is
displayed.
• CALL PRESET1 TO CONFIRM . . . . . . :
Use the joystick lever to search for the image to be
masked.
• POSITION:
Use the joystick lever to move the mask to the position
to be masked.
• SIZE:
Use the joystick lever to adjust the size of the mask.
The width can only be changed toward the right, and the
height can only be changed toward the bottom.
3 Masking display on/off (ACTIVATE)
This sets whether the masks for each mask preset number
that has been set using "MASK No." are displayed or not.
For example, if mask preset number "003" is set to "OFF",
the mask will disappear.
- 40 -
MASK No. : MASK No. : MASK No. : 001 001 001
SET SET SET
·ACTIVATE : ·ACTIVATE : ACTIVATE : ON ON ON
BACK BACK BACK
(Display mask)
English