Table of Contents
Advertisement
User Guide
3. Select the desired stripe size and press Enter. Available stripe sizes are 16, 32,
and 64 KB.
4. Enter the desired RAID Name in [Assign RAID Name] window and press
Enter.
■
A RAID Name must be unique, and up to 15 characters are
acceptable.
■
If a valid partition information or a boot block is detected in
the selected hard disk drive, a warning message will be dis-
played. Select [Yes] to continue creating an array, or [No] to
cancel the array creation.
■
Take to select the appropriate hard disk drives. If not, the
data will not be restored.
5. The message "Do you want to make this array as bootable?". Select either
[YES] or [NO], and then press Enter.
have been created. Refer to
6. When prompted with the message [Create Array?], select [Yes] and press
Enter.
Selecting [No] cancels the array creation and returns to the Main menu.
7. When prompted with the message [Are you sure?], select [Yes] and press
Enter.
Selecting [No] cancels the array creation and returns to the Main menu.
8. When the message [Build Completed] is displayed, press Esc to return to the
Main menu.
Deleting Arrays
To delete an array:
Before deleting an array, back up the hard disk drive data.
Deleted arrays cannot be restored.
1. On the main menu, highlight the array you wish to delete and press Enter.
Note: The boot priority can be changed after the arrays
Caution
"Boot Priority" on page
Caution
114
www.nec-computers.com
117.
Advertisement
Table of Contents
