Table of Contents
Advertisement
User Guide
6. Slide the cage completely out of the chassis.
7. Refer to the information provided with the hard disk drive for pre-installation
instructions.
8. Locate the slot in which you are going to install a hard disk drive. The system
has four slots, some of which may already be occupied.
9. Install the hard disk drive into the slot and secure it with 4 screws, for instance,
two in (A), and two on the other side.
Make sure to install hard disks starting from the upper slot.
10. Slide the cage back into the chassis as far as it will go.
11. Connect the data and power cables to their respective hard disk drives.
"Cabling SATA Devices" on page 152.
12. Tighten the thumbscrews.
13. Replace the front panel.
14. Replace the right side door.
Caution
See "Replacing the Front Panel" on page 125.
See "Replacing the Right Side Door" on page 124.
132
www.nec-computers.com
See
Advertisement
Table of Contents
