Table of Contents
Advertisement
User Guide
Cage for Fixed SCSI or S-ATA Drives
Figure 23: Cage for Fixed Hard Disk Drives (front view)
Removing the cage
1. Remove the right side door.
2. Remove the front panel.
3. Remove the 4 thumbscrews (C) holding the cage to the chassis.
4. Slightly pull out the hard disk drive cage.
5. Disconnect the data and power cables.
Be careful when working around the cables connected to the
already installed drives.
If necessary disconnect these cables, but be sure to note which
device each cable or power lead was attached to.
6. Slide the cage completely out of the chassis.
A: Hard disk drive screws
B: Fan bay
C: Thumb screws
See "Removing the Right Side Door" on page 122.
See "Removing the Front Panel" on page 125.
Caution
136
www.nec-computers.com
Advertisement
Table of Contents
