Table of Contents
Advertisement
User Guide
Available options are as follows:
- Create new RAID-1:Default
- Copy from (X) to (Y):Copy data from the disk of ID X to that of ID Y.
- Copy from (Y) to (X):Copy data from the disk of ID Y to that of ID X.
Double-check the copy source and copy destination. If they are
incorrect, the data will no longer be restored.
3. Enter the desired RAID Name in [Assign RAID Name] window and press
Enter.
■
A RAID Name must be unique, and up to 15 characters are
acceptable.
■
If a valid partition information or a boot block is detected in
the selected hard disk drive, a warning message will be dis-
played. Select [Yes] to continue creating an array, or [No] to
cancel the array creation.
■
Take to select the appropriate hard disk drives. If not, the
data will not be restored.
4. The message "Do you want to make this array as bootable?". Select either
[YES] or [NO], and then press Enter.
have been created. Refer to
5. When prompted with the message [Create Array?], select [Yes] and press
Enter.
Selecting [No] cancels the array creation and returns to the Main menu.
6. When prompted with the message [Are you sure?], select [Yes] and press
Enter.
Selecting [No] cancels the array creation and returns to the Main menu.
Note: The boot priority can be changed after the arrays
Caution
Caution
"Boot Priority" on page
112
www.nec-computers.com
117.
Advertisement
Table of Contents
