Fixed S-Ata Hard Disk Drives - NEC SA2500 User Manual

User Guide
9. Slide the cage back into the chassis as far as it will go.
10. Connect the data and power cables to their respective hard disk drives.
"Cabling a SCSI Hard Disk Drive" on page 151.
11. Tighten the thumbscrews.
12. Replace the front panel.
13. Replace the right side door.

Fixed S-ATA Hard Disk Drives

Installing a Fixed S-ATA Drive into the Cage
1. Remove the right side door.
2. Remove the front panel.
3. Remove the 4 thumbscrews (C) holding the cage to the chassis.
4. Slightly pull out the hard disk drive cage.
5. Disconnect the data and power cables.
Be careful when working around the cables connected to the
already installed drives.
When disconnecting cables, but be sure to note which device
each cable or power lead was attached to.
See "Replacing the Front Panel" on page 125.
See "Replacing the Right Side Door" on page 124.
A: Hard disk drive screws
B: Fan bay
C: Thumb screws
See "Removing the Right Side Door" on page 122.
See "Removing the Front Panel" on page 125.
Caution
131
www.nec-computers.com
See