Creating Arrays - NEC SA2500 User Manual

User Guide
Select [Yes] to exit and press any key to restart the computer. The changes you have
made become valid after the system restarts.

Creating Arrays

Follow the procedures below to create an array.
Requirements
Before creating arrays, make sure the disks for the array are connected and installed in
your system.
1. Start the SCSISelectUtility.
Select [Configure/View HostRAIDSettings] from Options menu of the channel
to create an array.
2. Press C on the main menu to create an array..
when the console redirection is used. It is safe to bypass this
issue.
■
At least two hard disk drives are required to create an array.
■
If hard disk drives of different capacities are used, the array
capacity is determined according to the smaller one.
■
Use only hard disk drives which models are supported by
the system.
Note: Some characters may not be displayed correctly
Caution
108
www.nec-computers.com