Selecting The Length Unit - GRAPHTEC FC4200-50 User Manual

7.5 Selecting the LENGTH UNIT

Your plotter's display panel can show coordinate values in units of either millimeters or inches. This LENGTH
UNIT function lets you switch the unit of length shown on the display panel.
Setting Procedure
(1) Press the PAUSE key, then press the
FORCE
F1
OPTION1
F2
SPEED
(2) Press the
F4
FORCE
F1
L UNIT
F2
SPEED
(3) Press the
F2
FORCE
F1
* mm
F2
SPEED
(4) The currently selected unit is indicated by the asterisk ( * ) symbol.
To display coordinate distances in millimeters, press the
To display them in inches, press the
(5) When the displayed setting is satisfactory, press the
(6) Press the PAUSE key to return the plotter to READY status.
NOTE
Your LENGTH UNIT setting will be retained in the plotter's RAM even while the plotter is turned off.
OPTION2
(OPTION 2) key to display the menu below.
DIST ADJ
TEST
(LENGTH UNIT) key to display the menu below.
LENGTH UNIT
inch
NEXT PAGE key until the menu below appears.
OFFSET
F3
F4
QUALITY
OFFSET
F3
F4
QUALITY
OFFSET
F3
F4
QUALITY
F2
(inch) key.
F4
ENTER key to register your setting.
7 – 5
(mm) key.