Bluetooth Communication - NTT docomo Arrows Kiss F-03E Instruction Manual

■ Overseas use
● Cannot use the terminal overseas even when signal
status icon is displayed.
Do you subscribe to WORLD WING? Check if you
subscribe to WORLD WING.
● 圏外 (Out of service) is displayed, and you cannot use the
terminal overseas.
•
Are you out of the international roaming service area or
in an area with poor signal strength?
•
Check if the service area and network operator are
available, referring to "Mobile Phone User's Guide
[International Services]" or DOCOMO International
Services website.
•
Change network mode type to [LTE/3G/GSM (Auto)].→
P171
•
Set the network operator to [Select automatically].→
P172
•
It may be recovered by turning the terminal OFF and
ON.
● Cannot use the terminal suddenly while using overseas.
Does usage amount exceed the limit of maximum charges
for use? For use of International roaming (WORLD WING),
the limit of maximum charges for use is set in advance.
When it exceeds the limit of maximum charges for use,
pay the charges.
● There is no incoming call overseas.
Is Restricting incoming calls set to [Activate restricting]?→
P173
● No caller ID is notified/A notified caller ID is different
from that of the caller/Functions for using contents
saved in Phonebook or those using Caller ID notification
do not operate.
Even when a caller notifies its caller ID, it is not displayed
on the terminal unless notified from the network or
network operator used. And, a notified caller ID may be
different from that of the caller by some networks or
network operators you use.
● Cannot perform data communication overseas.
Check the data roaming settings.→P172
■ Data management
● Data saved in microSD card is not displayed.
Reattach the microSD card.→P31
● Data transfer is not performed.
Do you use USB HUB? If you use USB HUB, operations
may not be performed correctly.
■ Bluetooth
● The terminal cannot be connected to a Bluetooth device/
A Bluetooth communication device cannot be found
from the terminal.
Make Bluetooth device registering stand-by state and then
register the device on the terminal. If you delete already
registered device and register the device again as a new
device, delete the registrations on both the terminal and
Bluetooth device and then perform registration of the
devices.
181
Appendix/Index