Welding Functions - Kemppi KempArc Pulse 350 Operating Manual

4.3.2 welding functions

othEr proCEssEs
HotStart
HOTStartLevel
Hot 2T Time
CraterFill
CraterStart
CraterFillEnd
CraterTime
Creep Start
StartPower
wIsEroot / wIsEthIn
HotStart
EN
HOTStartLevel
Hot 2T Time
CraterFill
CraterStart
CraterFillEnd
CraterTime
Creep Start
AdVAnCEd FunCtIons
WisePenetration
Penet%(123A)
WiseFusion
WiseFusion%
MatchLogLevel
14
(in edit Channel menu 3/6)
ON, OFF or USER Factory setting is USER =>
USER can freely choose is the
HotStart ON or OFF
-50 – 100 % 1 % steps. Factory setting 40 %
0 – 9.9 s 0.1 s steps. Factory setting 1.2 s
ON, OFF, USER Factory setting is USER =>
USER can freely choose is the
CraterFill ON or OFF
10 – 250% Factory setting is 100%
10 – 250 %, not 1 % steps. Factory setting 30% Set the level of the curve where the crater
higher than start
0.0 – 10.0 s 0.1 s steps. Factory setting 1.0 s CrateFill Slope Time
10 – 99% 1% steps. OFF, CURVE
(OFF = 100%)
-9 – 9 Factory setting is 0
ON, OFF or USER Factory setting is USER =>
USER can freely choose is the
HotStart ON or OFF
-50 – 100 % 1 % steps. Factory setting 40 %
0 – 9.9 s 0.1 s steps. Factory setting
1.2 s
ON, OFF, USER Factory setting is USER =>
USER can freely choose is the
CraterFill ON or OFF
10 – 250% Factory setting is 100%
10 – 250 %, not 1 % steps. Factory setting 30%
higher than start
0.0 – 10.0 s 0.1 s steps. Factory setting
1. 0 s
10 – 99% 1% steps. OFF, CURVE
(OFF = 100%)
ON or OFF
-30 – 30 % Factory setting: 0 %
ON or OFF
20 - 60 % or CURVE Factory setting is CURVE
-50 – 100%
Set the level of the curve where the crater
filling will start
filling will end.
Factory setting is CURVE (Creep Start value
comes from Welding Curve).
Adjusts arc ignition
Set the level of the curve where the crater
filling will start.
Factory setting is CURVE (Creep Start value
comes from Welding Curve).
Penetration control selection
Wise penetration percent setting. Set
penetration Current.
WiseFusion selection
When WISE FUSION is ON it controls the
amount of short circuits in the arc. The
lower the value there will be less short
circuits in the arc. The higher the value
there will be more short circuits in the arc.
Set the "MiniLog level"
Only in use in case of manual feeder.