Welding Functions - Kemppi FastMig X 350MV Manual

MMA PROCESSES
Current
CurrentMax
CurrentMin
ArcForce
StartPower
CC PROCESS
Current
CurrentMax
CurrentMin
Dynamics
EN
StartPower
CV PROCESS
Voltage
VoltageMax
VoltageMin
Dynamics
StartPower
4.4

Welding functions

WISEROOT+ AND OTHER PROCESSES
2T/4T
HotStart
HotStartLevel
Hot 2T Time
CraterFill
CraterStart
CraterFillEnd
CraterTime
16
FastMig X 350MV
14...350 A
14...350 A
14...350 A
-9...+9 Factory setting is 0
-9...+9 Factory setting is 0
10...350 A
10...350 A
10...350 A
-9...+9 Factory setting is 0
-9...+9 Factory setting is 0
10...50 V
10...50 V
10...50 V
-9...+9 Factory setting is 0
-9...+9 Factory setting is 0
2T, 4T, MATCHLOG, Factory setting is USER (user
USER chooses the switching logic)
ON, OFF, USER Factory setting is USER (user
chooses ON or OFF)
-50...+100 % Step: 1
Factory setting 40%
0...9.9 s Step: 0.1
Factory setting is 1.2 s
ON, OFF, USER Factory setting is USER (user
chooses ON or OFF)
10...250 % Factory setting is 100%
10...250 %, not Step: 1
higher than start Factory setting is 30%
0.0...10.0 s Step: 0.1.
Factory setting is 1.0 s
Welding current
Set the limit for maximum current value
Set the limit for minimum current value
Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
Adjusts arc ignition
Welding current
Set the limit for maximum current value
Set the limit for minimum current value
Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher the
value the rougher the arc is.
Adjusts arc ignition
Welding voltage
Set the limit for maximum voltage value
Set the limit for minimum voltage value
Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher the
value the rougher the arc is.
Adjusts arc ignition
Sets switching logic
Sets the level of the curve where the crater
filling will start
Sets the level of the curve where the crater
filling will end.
Sets slope time for crate filling