Welding Functions - Kemppi FastMig X 450 Operating Manual

CC PROCESS
Current
CurrentMax
CurrentMin
Dynamics
StartPower
CV PROCESS
Voltage
VoltageMax
VoltageMin
Dynamics
EN
StartPower
4.4

Welding functions

WISEROOT+ AND OTHER PROCESSES
2T/4T
HotStart
HotStartLevel
Hot 2T Time
CraterFill
CraterStart
CraterFillEnd
CraterTime
Crater 4T Timer
16
FastMig X 450
10...450 A
10...450 A
10...450 A
-9...+9 Factory setting
is 0
-9...+9 Factory setting
is 0
10...50 V
10...50 V
10...50 V
-9...+9 Factory setting
is 0
-9...+9 Factory setting
is 0
2T, 4T, Factory setting is USER (user
MATCHLOG, USER chooses the switching logic)
ON, OFF, USER Factory setting is USER (user
chooses ON or OFF)
-50...+100 % Step: 1
Factory setting 40%
0...9.9 s Step: 0.1
Factory setting is 1.2 s
ON, OFF, USER Factory setting is USER (user
chooses ON or OFF)
10...250 % Factory setting is 100%
10...250 %, not Step: 1
higher than start Factory setting is 30%
0.0...10.0 s Step: 0.1.
Factory setting is 1.0 s
On, OFF Factory setting is OFF
Welding current
Set the limit for maximum current value
Set the limit for minimum current value
Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher
the value the rougher the arc is.
Adjusts arc ignition
Welding voltage
Set the limit for maximum voltage value
Set the limit for minimum voltage value
Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher
the value the rougher the arc is.
Adjusts arc ignition
Sets switching logic
Sets the level of the curve where the
crater filling will start
Sets the level of the curve where the
crater filling will end.
Sets slope time for crate filling
ON: if 4T is selected, crater filling will
last at least time that has been adjusted
by CraterTime or as long as trigger is
pressed.
OFF: if 4T is selected, crater filling will
last as long as trigger is pressed.