Welding Functions - Kemppi FastMig Pulse 350 Operating Manual

4.3.2 Welding functions

OTHER PROCESSES
2T/4T
HotStart
HotStartLevel
Hot 2T Time
CraterFill
CraterStart
CraterFillEnd
CraterTime
Crater 4T Timer
Creep Start
StartPower
WISEROOT / WISETHIN
2T/4T
HotStart
HotStartLevel
Hot 2T Time
CraterFill
CraterStart
CraterFillEnd
CraterTime
© Kemppi Oy / 1515
2T, 4T, MATCHLOG Factory setting is USER =>
or USER USER can freely choose the
switching logic
ON, OFF or USER Factory setting is USER =>
USER can freely choose is the
HotStart ON or OFF
-50 ... +100 % 1 % steps. Factory setting 40%
0.0 – 9.9 s 0.1 s steps. Factory setting 1.2 s
ON, OFF, USER Factory setting is USER =>
USER can freely choose is the
CraterFill ON or OFF
10 – 250% Factory setting is 100%
10 – 250 %, not 1 % steps. Factory setting 30% Set the level of the curve where the crater
higher than start
0.0 – 10.0 s 0.1 s steps. Factory setting 1.0 s CrateFill Slope Time
On or OFF Factory setting is OFF
10 – 99% 1% steps. OFF, CURVE
(OFF = 100%)
-9 ... +9 Factory setting is 0
2T, 4T, MATCHLOG Factory setting is USER =>
or USER USER can freely choose the
switching logic
ON, OFF or USER Factory setting is USER =>
USER can freely choose is the
HotStart ON or OFF
-50 ... +100 % 1 % steps. Factory setting 40%
0.0 – 9.9 s 0.1 s steps. Factory setting
1.2 s
ON, OFF, USER Factory setting is USER =>
USER can freely choose is the
CraterFill ON or OFF
10 – 250% Factory setting is 100%
10 – 250%, not 1 % steps. Factory setting 30%
higher than start
0.0 – 10.0 s 0.1 s steps. Factory setting
1. 0 s
Set switching logic
Set the level of the curve where the crater
filling will start
filling will end.
ON: if 4T is selected crater filling will last
at least time that has been ad-justed by
CraterTime or as long as trigger is pressed.
OFF: if 4T is selected crater filling will last as
long as trigger is pressed.
Factory setting is CURVE (Creep Start value
comes from Welding program).
Adjusts arc ignition
Set switching logic
Set the level of the curve where the crater
filling will start.
EN
15