Kemppi KempArc Pulse 350 Operating Manual page 18

AdmInIstrAtor mEnu
Change PIN Code
Ask PIN
Button FunCtIons
ON / OFF Button
F1 Button
EN
F3 Button (WF#)
Channel +/-
Up/Down Button
Right/Left
selection buttons
(Soft Keys)
16
(in main menu 2/7, user identification)
Administrator pin code Factory PIN code: 0000.
change.
PIN code inquiry selection: Factory Setting: OFF
OFF / StartUp / Menu
Short Press: Panel returns to default start-up display view (Channel info display).
Long Press: When setup panel (K 60) is ON => Setup panel and all KF 62 panels are turned OFF.
When setup panel is OFF => Setup panel and all KF 62 panels are turned ON.
Pressed while machine is turning ON: Restore to factory shortcut. Panel will ask confirmation to
restore factory setting.
If Setup panel is OFF and some other KF 62 panel is turned ON the Setup Panel turns also ON and will
be linked automatically to this KF panel (WF# function).
F1 button gives further information of selected memory channel.
Pressed while machine is turned ON: Restore language selection to English.
F3 button can be used to select Wire Feeder.
Panel allows selecting only those WF numbers that are found connected on the sys-tem.
Memory channel selection.
Moving Up/Down in menu.
Button function depends on where in menu you are.
OFF: No PIN code inquiry.
StartUp: Setup panel (K 60) always
asks for the PIN code when the
machine is turned on. KF 62 is not
affected and always works without
PIN.
Menu: Setup panel (K 60) asks
every time for PIN code when MENU
button is pressed and when the
display is in channel info mode i.e.
in start-up view. PIN code inquiry is
made only once when entering the
menu. After that the menu button
can be pressed any time without PIN
inquiry.