Thread Take-Up Cover Removal; Tension Base Removal - Brother PR600 Service Manual

Main unit
11

Thread take-up cover removal

1. Remove the 2 screws 1, and then remove the thread take-up cover 1.
*Key point
• The pin protruding from the needle bar case final assembly
rests on the inner left side of the thread take-up cover.
Start movie clip (CD-ROM version only)
12

Tension base removal

1. Remove the screw 1, and then remove the cord clamp NK-4N from the
arm bed.
2. Remove the 4 screws 2, and then remove the tension base assembly.
Start movie clip (CD-ROM version only)
2 - 10
Main parts
1
1
1
2 2