Power Switch Assembly And Inlet Attachment - Brother PR600 Service Manual

Main unit
5

Power switch assembly and inlet attachment

1. Connect the free end of the 2 power lead wire assemblies 1 (one end is
connected to the power PCB assembly) to the power switch assembly 2.
*Key point
• Connect each of the power lead wires to the terminal adjacent
to the rocker switch lead wire of the same color.
2. Attach the power switch assembly to the base frame with the 2 screws 1.
3. Attach the inlet cover 3 to the base frame with the 2 screws 2.
4. Place the power switch assembly's rocker switch 4 in the inlet cover (pay
attention to the direction), and then attach the inlet cover lid with the 2
screws 3.
5. Attach the power lead wire assembly to the base frame with the screw 4
and the cord clamp (NK-6N).
6. Attach the USB lead wire assembly and the Y-area sensor assembly's lead
wire to the base frame with the screw 5 and the cord clamp (NK-6N).
7. Attach the power PCB assembly's lead wire to the base frame with the
screw 6 and the cord clamp (NK-6N).
1
2
3
4
5
6
Power unit
Screw, Pan (S/P washer)
0.78 – 1.18 N-m
M4X8DB
Color; Silver
Taptite, Bind B
0.39 – 0.78 N-m
M3X8
Color; Gold
Screw, Pan (S/P washer)
0.78 – 1.18 N-m
M4X8DB
Color; Silver
3
1
6
Torque
Torque
Torque
1
2
4
2
3
5 4
3 - 31