Error Message List - Brother PR600 Service Manual

Failure Investigation for Electronic Parts Error message list

Error message list

Inappropriate needle stop position.
Needle bar case position error.
Needle case motor has been locked.
Needle bar case home position error.
Check if thread is broken.
Check if lower thread is broken.
X-axis home position error.
Y-axis home position error.
XY moving error.
EEPROM read/write error.
EEPROM read error.
Main motor rotate error.
Main motor lock.
Main motor encoder signal error.
Main motor encoder connect error.
Main motor current error.
Trimming sensor error.
Wiper error.
Sewing data error.
Needle threadder error.
Picker error.
Main motor speed error.
Power supply voltage error.(24V high)
Power supply voltage error.(24V low)
Power supply voltage error.(40V high)
Power supply voltage error.(40V low)
Panel communication error.
Comminication time out error.
Data receiving command error.
Comminication error.
No disk inserted or this disk may be defective.
Can not use this disk.
Floppy disk read error.
Save error.
Floppy disk erase error.
cannot format.
No CompactFlash card.
5 - 2
See page Error message list
5 - 12 Can not use this card.
5 - 8 CompactFlash card read error.
5 - 8 Save error.
5 - 8 CompactFlash Card erase error.
5 - 9 cannot format.
5 - 9 USB read error.
5 - 10 Pocket read error.
5 - 23 Save error.
5 - 12 Delete error.
3 - 101 Embroidery card read error.
There is no memory card in card slot. Insert
3 - 5
a memory card.
5 - 12 This card cannot be used.
5 - 12 Frame area over.
5 - 24 Change it to the big frame
5 - 24
5 - 25
5 - 13
5 - 14
5 - 26
5 - 15
5 - 16
5 - 12
5 - 27
5 - 27
5 - 27
5 - 27
5 - 26
5 - 26
5 - 26
5 - 26
5 - 17
5 - 17
5 - 17
5 - 17
5 - 17
5 - 17
5 - 18
See page
5 - 18
5 - 18
5 - 18
5 - 18
5 - 18
5 - 19
3 - 5
3 - 5
3 - 5
5 - 18
5 - 18
5 - 18
5 - 20
5 - 20