Choosing The Network Type From The Printer Screen; Choosing The Network Type Using Printer Commands - Intermec PM4i User Manual

Chapter 3 — Configuring the Printer

Choosing the Network Type From the Printer Screen

Choosing the Network Type Using Printer Commands

80
To configure the printer from the screen, you need to enter Setup
mode.
To choose the network type from the printer screen
1 Press T to enter Setup mode.
2 Navigate to Network > Network Type and press E.
3 Select either Ethernet or Wireless 802.11 and press E.
4 Press T to exit Setup mode.
5 Reboot the printer for the change to take effect.
You can use a serial connection to send Fingerprint or IPL commands
the printer.
To choose the network type using printer commands
1 Connect your printer to your PC using a serial cable. For help, see
"Connecting the Printer to a PC Through the Serial Port" on
page 42.
2 Start a terminal application, such as HyperTerminal.
• If you are running Fingerprint, send this command to the
printer:
setup "NETWORK","NETWORK TYPE","n"
where n is either Ethernet or Wireless 802.11.
• If you are using IPL, send this command to the printer:
<STX><SI>n,,,p<ETX>
where p is either 0 (select Ethernet interface) or 1 (Select Wireless
802.11 interface).
3 Reboot the printer for the change to take effect.
PM4i Mid-Range Printer User's Manual