Choosing The Network Type From The Printer Screen; Choosing The Network Type Using Printer Commands - Intermec PF2i User Manual

Choosing the Network Type From the Printer Screen

Choosing the Network Type Using Printer Commands

PF2i and PF4i Mid-Range Printer User's Manual
To configure the printer from the screen, you need to enter Setup
mode.
To choose the network type from the printer screen
1 Press T to enter Setup mode.
2 Navigate to Network > Network Type and press E.
3 Select either Ethernet or Wireless 802.11 and press E.
4 Press T to exit Setup mode.
5 Reboot the printer for the change to take effect.
You can use a serial connection to send Fingerprint or IPL commands
the printer.
To choose the network type using printer commands
1 Connect your printer to your PC using a serial cable. For help, see
"Connecting the Printer to a PC Through the Serial Port" on
page 42.
2 Start a terminal application, such as HyperTerminal.
• If you are running Fingerprint, send this command to the
printer:
setup "NETWORK","NETWORK TYPE","n"
where n is either Ethernet or Wireless 802.11.
• If you are using IPL, send this command to the printer:
<STX><SI>n,,,p<ETX>
where p is either 0 (select Ethernet interface) or 1 (Select Wireless
802.11 interface).
3 Reboot the printer for the change to take effect.
Chapter 3 — Configuring the Printer
89