Adjusting The Label Stop Sensor - Intermec PM4i User Manual

Adjusting the Label Stop Sensor

PM4i Mid-Range Printer User's Manual
Chapter 4 — Troubleshooting and Maintaining the Printer
2 Loosen the nut that secures the pressure arm.
Center of media
3 Move the pressure arm inward or outward until the arrow on the
tip of the arm is centered with the media.
Note: Move the pressure arm at the part closest to the screw, not at
the tip. If the arm is difficult to move, lift the printhead and pull
the printhead bracket free from the magnet in the arm.
4 When the pressure arm is centered, tighten the nut to secure the
arm.
5 Adjust the edge guides.
The label stop/black mark sensor (LSS) is a photoelectric sensor that
controls the printer's media feed by detecting gaps between labels, or
slots or black marks in continuous stock, depending on the printer's
media type setup. The LSS must be aligned with the gaps, slots, or
black marks. If you are using irregularly shaped labels, align the LSS
with the front tips of the labels.
Pressure arm
Upper label
stop sensor
Edge guide
99