Intermec PM4i User Manual page 141

PM4i Mid-Range Printer User's Manual
Tickets With Black Mark (Mark Stock)
Media Width (a)
Measurement Value
Maximum 114.3 mm (4.50 in)
Minimum 25.0 mm (1.00 in)
Copy Length (b)
Measurement Value
Maximum Dependent on SDRAM size
Minimum 8.0 mm (0.32 in)
LSS Detection Position (c)
This position is variable. For help, see
Sensor" on page 99.
Black Mark Width (d)
The detectable width of the black mark should be at least 5.0 mm
(0.2 in) on either side of the LSS detection point.
Black Mark Length (e)
Measurement Value
Maximum 21.3 mm (0.83 in)
Common 12.5 mm (0.5 in)
Minimum 5.0 mm (0.2 in)
Black Mark Y-Position (f)
Intermec recommends that you place the black mark as close to the
front edge of the ticket as possible and use a negative Stop Adjust
value to control the media feed, so the tickets can be properly torn off.
Appendix A — Specifications
"Adjusting the Label Stop
127