Intermec PM4i User Manual page 96

Chapter 3 — Configuring the Printer
82
To upgrade using a USB storage device
1 Turn on your printer.
2 Verify the USB storage device is supported by your printer. Insert
the USB storage device in the appropriate slot on the back of your
printer. On the display screen, one of the following status
messages briefly appears:
• USB memory stick connected
• USB memory stick not supported
Note: If no status message appears when you insert the USB
storage device, remove and reinsert the USB storage device. To
manually verify the USB storage device is supported, see
USB Mass Storage Device" on page
3 Insert the USB storage device in the appropriate slot on your PC.
4 In the root directory of the USB storage device, create a folder
named "upgrade."
5 Copy the firmware binary upgrade file to the upgrade folder on
the USB storage device.
Note: The printer supports 8.3 binary filenames, which means the
filename can have up to eight characters and a .bin extension.
6 Insert the USB storage device in the appropriate slot on the back
of your printer. The upgrade starts. On the display screen, the
status message, "Time Out," appears.
7 When the upgrade is complete, the status message, "Check
Integrity," appears. Remove the USB storage device. You may need
to restart your printer.
To upgrade using a serial or USB connection
• Use Fingerprint or IPL commands to send the upgrade file to your
printer.
For help, see the
or the IPL Command Reference
To upgrade using an Ethernet or 802.11 network connection
1 Start your web browser application.
Intermec Fingerprint Command Reference Manual
Manual.
PM4i Mid-Range Printer User's Manual
"Using a
57.