Configuring Alerts - Intermec PM4i User Manual

PM4i Mid-Range Printer User's Manual

Configuring Alerts

Use the Alerts page to view and change the printer alert settings.
To configure alerts
1 Click Printer > Alerts.
2 Change the alert settings:
• From the Setting list, choose Enabled or Disabled.
• In the text field, specify a Delay repeat.
• In the Delay Unit list, select seconds or occurrences.
• In the Message text field, enter a message.
3 Select the Notification method.
4 Click Submit Settings.
Use the following table to understand the Alert Settings.
Understanding the Alert Settings
Setting
Label Not Taken
(Fingerprint only)
Cutter Error
Head Lifted
Out of Ribbon
Pause Mode
Setup Mode
Error Condition
(Fingerprint only)
Application Break
(Fingerprint only)
Print Job Complete
(Fingerprint only)
Chapter 3 — Configuring the Printer
Description
Sent when the printed label is not taken from the
printer. This setting applies to label and ticket media
and requires an optional label taken sensor.
There was an error related to the label cutter.
A printer job was sent to the printer while the
printhead was lifted.
You have thermal transfer ribbon selected and the
printer is out of ribbon.
The printer is in Pause mode.
The printer is in Setup mode.
An error has occurred in the Fingerprint application.
The error does not have to be critical to the print job for
the printer to send this alert.
A running Fingerprint application has been
interrupted manually or because of an error.
The print job has been successfully completed.
67