Intermec PM4i User Manual page 114

Chapter 4 — Troubleshooting and Maintaining the Printer
100
The LSS can be moved laterally from the inner edge of the media path
to 57 mm (2.24 in) outward, which corresponds to the center line of
full width media. One part of the sensor is on the upper media guide
and the other part of the sensor is under the lower guide.
To adjust the LSS
1 Use a slotted screwdriver to turn the adjustment screw.
• Rotate the screw clockwise to move the sensor toward the
center section.
• Rotate the screw counterclockwise to move the sensor outward,
away from the center section.
2 Look at the print mechanism from the front with the printhead
lifted to make sure that the point of detection on the upper sensor
is aligned with the center of the slots or marks in the media.
To test the LSS
1 Make sure that your printer is properly configured for the type of
media you are using. Go to SETUP > MEDIA > MEDIA TYPE.
2 Open the right door.
3 Lift and lower the printhead.
4 Press the B button.
5 Make sure there is a label (not a gap or mark) at the LSS.
Point of
detection
Adjustment
screw
PM4i Mid-Range Printer User's Manual