Part names and functions
Remote control
②
①
INPUT
VGA
VIDEO
HDMI
③
AUTO
MENU
⑥
⑧
KEYSTONE
IMAGE
FREEZE
PATTERN
⑩
⑪
SCREEN
LAMP
MUTE
INFO.
⑭
BLANK
⑮
+
+
⑱
D.ZOOM
VOLUME
TIMER
-
-
⑲
① POWER
Turn on or turn off the projector.
② INPUT
Open or close the input source menu.
③ VGA
Select "Computer 1" as input source.
④ VIDEO
Select "Video" as input source.
⑤ HDMI
Select "HDMI" as input source.
⑥ AUTO
Enter auto setup adjust mode.
⑦ MENU
Open or close the screen menu.
12
⑧ button
- Select item or adjust data in screen
menu.
- Select the image display area in
digital zoom + mode.
④
⑨ OK
Enter the menu or select an item in
⑤
the menu.
⑦
⑩ KEYSTONE
⑨
Correct the keystone distortion.
⑪ IMAGE
Select the image mode.
⑫
⑬
⑫ FREEZE
⑯
Freeze the projected image.
⑰
⑬ PATTERN
⑳
Set the internal test image.
㉑
⑭ SCREEN
Select the screen size.
⑮ LAMP
Select the lamp mode.
⑯
MUTE
Turn off the volume.
INFO.
⑰
Display the projector information.
D.ZOOM + / -
⑱
Digital zoom in / zoom out the image.
VOLUME + / -
⑲
Increase /
the volume.
decrease
BLANK
⑳
Temporarily close the image on the
screen.
TIMER
㉑
Enable the timer function.
Part names and functions
Install remote control batteries
②Install new batteries.
① Open the battery
cover.
To ensure safe operation, please observe the following precautions:
● Use two (2) AAA or LR3 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked in the remote control, carefully wipe the case clean and
install new batteries.
● Risk of explosion if two batteries are replaced by an incorrect type.
● Dispose of used batteries according to the instructions on the battery or local
regulations or guides.
Operating range
Point the remote control toward the remote
control receivers on the projector (front and
back) when pressing any button.
The maximum operating range for the remote
control is about 5 meters and 60 degrees.
③
Put the cover
back.
Two AAA batteries
For correct polarity
(+ and –), be sure
battery terminals
are in contact
with pins in the
compartment.
30°
5m
30°
30°
5m
13