Install Remote Control Batteries; Operating Range; Adjustable Foot - Eiki LC-XNS2600 Owner's Manual

Part names and functions

Install remote control batteries

① Open the battery
compartment lid.
To ensure safe operation, please observe the following precautions:
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and
install new batteries.
● Risk of explosion if a battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions on the battery or local
regulations or guides.

Operating range

Point the remote control toward the projector
remote receiver when pressing any button.
The maximum operating range for the remote
control is about 5 meters and 60 degrees
vertically and horizontally.

Adjustable foot

The projection angle can be adjusted up to 10
degrees with the adjustable foot.
Lift the front of the projector up and press the
lock on the adjustable foot to release it.
Release the lock and the foot is then locked.
Adjust the height and tilt angle by rotate the
foot.
Keystone distortion of projected images can be
corrected by remote control or menu operation.
14
② Install new batteries
into the compartment.
Two AAA batteries
For correct polarity
(+ and –), be sure
battery terminals
are in contact
with pins in the
compartment.
30°
30°
5m
Adjustable foot
③
Replace the
compartment lid.