Before Adding A Humidifier; To Add (Or Remove) A Humidifier; Add Non-Communicating Device - Lennox iComfort Wi-Fi Setup Manual

NON-COMMUNICATING EQUIPMENT — ADDING A HUMIDIFIER
Before adding a humidifier, be sure that:
• The humidifier is wired to the furnace or air handler
control as shown on the optional accessories wiring
diagram.
• The entire system is wired, powered up, and the
thermostat has detected the system's installed com­
municating devices, and you are at the Add or Re­
move Non-communicating equipment? screen.
system devices
System
Heat Pump
Furnace
Thermostat
non-communicating device list
Humidifier
Dehumidifier
Electronic Air Cleaner
Humidifier
Select one
3a
Not Installed
3b
save
non-communicating device list
Humidifier
Dehumidifier
Electronic Air Cleaner
Humidifier
Select one
3a
Not Installed Bypass (24VAC) Humidifier
Power (120VAC Humidifier
3b
save
non-communicating device list
Humidifier
Dehumidifier
Electronic Air Cleaner
Humidifier
Select one
3a
Not Installed Bypass (24VAC Humidifier
3b
save
507343-01
Add or Remove Non-
communicating
1
equipment?
back
to add/remove/adjust a device,
select it, then press edit
current value:
2a
Not Installed
2b
Humidification
Options available
for EL296 and
cancel
SL280
to add/remove/adjust a device,
select it, then press edit
current value:
2a
Not Installed
2b
Bypass and Power Humidifier
Options available
cancel
for SLP98
to add/remove/adjust a device,
select it, then press edit
current value:
2a
Not Installed
2b
Options
available for
cancel
CBX32MV and
CBX40UHV
Figure 7. Add Non-Communicating Device — Humidifier

To add (or remove) a humidifier:

1. Press the yes button on this screen (see 1).
2. In the "non-communicating device list" screen, use the
arrows (2a) to highlight Humidifier (note the current
value, Not Installed) and press edit (2b).
3. Touch one of the radio buttons (3a) to select humidific­
ation equipment type. Options available are dependent
on indoor unit model.
4. The previous screen returns, but the current value
now shows your selection (4a). Press the back (4b)
yes
button.
5. The Add or Remove... screen reappears with your
addition shown in the system devices list (5a). At this
point, you may add more equipment (press yes) or if
finished, press the next (5b) button to advance to the
Adjust a setting... screen (see page 18).
next
NOTE - Adding humidity regulating non-communicating de­
vices may be a 2-step procedure:
1st, the device must be installed and wired. After the hu­
midifier is installed, the setting under the System mode
Humidification Control Mode defaults to Basic).
2nd, (if you want another mode, i.e. Precision, Basic Dew
Point, or Precision Dew Point, the device requires further
configuration (see page 18).
edit
non-communicating device list
edit
Humidifier
Dehumidifier
Electronic Air Cleaner
system devices
System
Heat Pump
Furnace
edit
Thermostat
Bypass (24VAC) Humidifier
9:39 am Aug 15, 2012
Page 6
to add/remove/adjust a device,
select it, then press edit
current value:
xxxxxxxxxxxxxxxxxxxxxxxr
4a
4b
back
Add or Remove Non-
communicating
equipment?
5a
back
edit
yes
5b
next