Registering The Icomfort Wi-Fi; Registration For Online Access; Access Point Info - Lennox iComfort Wi-Fi Setup Manual

2. Select the access point that has already been establish
and connected too. There are two options to select from
which are connect and AP info. Select AP Info and verify
the RSSI strength. If the signal is anywhere between -1 to
-69, then the signal strength is sufficient. If outside this
range, the either locate the router closer to the thermostat
or add a repeater.

ACCESS POINT INFO

Detailed information for the access point
MAC=
WSTATE=CONN.
BSSID=68
RSSI= -46
IP addr=
Figure 31. Verifying Signal Strength

Registering the iComfort Wi-Fi

REGISTRATION FOR ONLINE ACCESS

1. From the WI-FI SETTINGS screen, press either the
thermostat not registered icon or the connection
status icon and select the server icon.
WI-FI SETTINGS
connectio
Wi-Fi
n status
enabled
press to change press to enable /
network settings disable Wi-Fi
2. Enter homeowner email address and system description
and press the register button.
Register with iComfort Wi-Fi thermostat to enable remote access and
enter your email
System Desc
®
iComfort Wi-Fi
®
Thermostat
thermostat
AP3
not
connected
registered
press to change
press to toggle
thermostat
off / auto
registration
online weather information
register
3. A pop-up screen asking if the email address below is
correct? Verify the email address is correct and press yes.
4. Another pop-up screen will appear notifying the user to
check their email.
An email has been sent to
xxxxxxxxxx@lennoxind.com
with instructions on how to register your thermostat. If you haven't
received the email, please check your spam folder and make sure
that your email address is correct.
NOTE - If the email address originally entered is incorrect,
return to the thermostat registered screen and reenter the
correct information and press register.
5. After the iComfort Wi-Fi
network link, registration and account creation must be
completed on the homeowners personal computer (see
Page 28).
NOTE - Time from pushing the registration button on the
thermostat and receiving the consumer portal register link
from your email on your computer is normally from 5 to 15
minutes.
6. After registration has been completed, press the
connection status icon to verify the connection was
successful. If the connection is successful the server icon
background will be green.
7. After successful connection to the server is completed,
the firmware update button will appear. The default setting
is set to auto. If any firmware updates are available they
will immediately start downloading and update the
thermostat. The thermostat will reboot itself after the
update is completed.
This auto update feature can be disabled by pressing the
firmware update button to toggle to OFF but is not
recommended.
NOTE - Firmware updates will not affect installer or user
thermostat settings. Both will be retained after the update.
WI-FI SETTINGS
connection Wi-Fi
status
enabled
press to see press to enable /
connection status disable Wi-Fi
NOTE -
If any downloads are available for the thermostat they will start downloading
right away. When new firmware is being downloaded or when Gelaskins are
being installed, the thermostat screen will temporarily go blank and running
units may cease operation while the system is being reset to accommodate
Connection to server has not bee established or it has been lost.
the new changes. This is normal and can last a couple minutes.
Please wait until a connection is established.
Figure 32. Registration for Online Access
7-Day Programmable Communicating Thermostat
Page 27
®
server sends the email with the
AP3
thermostat
connected registered
press to change
press to change
thermostat
wireless network
registration
firmware
update
auto
press to search
for new update