Humidifier - Lennox icomfort Wi-Fi Setup Manual

Add (or Remove) Humidifier (skip if no humidifier is being used)
Before adding a humidifier, be sure that:
S the humidifier is wired to the furnace or air handler control as shown on the Optional
Accessories wiring diagram (see Page 61),
S the entire system is wired, powered up, and the thermostat has detected the system's
installed communicating devices, and you are at the Add or Remove Non−communi-
cating equipment?" screen (see figure 7, Page 8).
system devices
System
Heat Pump
Furnace
non−communicating device list
Thermostat

Humidifier

Dehumidifier
Electronic Air Cleaner
Humidifier
Select one
3a
Not Installed
Power (120VAC) Humidifier
(available with furnace equipped systems only)
3b
save
non−communicating device list
Humidifier
Dehumidifier
Electronic Air Cleaner
Add or Remove Non−
1
communicating
equipment?
to add/remove/adjust a device,
select it, then press edit
current value:
2a
Not Installed
2b
back
Bypass (24VAC) Humidifier
Bypass and Power Humidifier
cancel
to add/remove/adjust a device,
select it, then press edit
current value:
Bypass (24VAC) Humidifier
4a
4b
back
Figure 9. Add or remove non−communicating device HUMIDIFIER
NOTE − Adding humidity regulating non−communicating devices may be a 2−step procedure:
1st, the device must be installed (this page; after the humidifier is installed, the operation
mode defaults to Basic").
2nd, (if you want another mode, i.e. Precision, Basic Dew Point, or Precision Dew Point,
the device requires further configuration (see Page 15).
To add (or remove) a humidifier,:
1. Press the yes button on this screen (see 1).
yes
2. In the non−communicating device list" screen, use the arrows (2a) to highlight
Humidifier (note the current value, Not Installed) and press edit (2b).
3. Touch one of the radio buttons (3a) to select the type of humidifier (or select Not
Installed, if removing humidifier); press save (3b).
4. The previous screen returns, but the current value now shows your selection (4a).
Press the back (4b) button.
5. The Add or Remove..." screen reappears with your addition shown in the system
devices list (5a). At this point, you may add more equipment (press yes) or if
finished, press the next (5b) button to advance to the Adjust a setting..." screen
(see page 15).
edit
next
6. (If you want other than the default Basic" mode of operation) Configure the
humidifier as described on Page 15.
system devices
System
Heat Pump
Furnace
Thermostat
Bypass (24VAC) Humidifier
edit
9:39 am Aug 15, 2012
icomfort Wi-Fit 7−Day Programmable Communicating Thermostat
Page 11
Add or Remove Non−
communicating
equipment?
5a
back
yes
5b
next