Identifying System Devices; Non-Communicating Equipment - Adding Outdoor Unit, Dehumidifier And Humidifier - Lennox iComfort Wi-Fi Setup Manual

Identifying System Devices

From the "system devices" screen, use arrow buttons to scroll to a device; then press the about button. Use the up/down arrows to
scroll through and view additional information about the selected device. When finished viewing, press the back button.
system devices
System
Heat Pump
Furnace
Thermostat
9:39 am Aug 15, 2012
Non-Communicating Equipment — Adding Outdoor Unit, Dehumidifier and Humidifier
NON-COMMUNICATING EQUIPMENT — ADDING OUTDOOR UNIT
System Devices
System
Furnace
non-communicating device list
Outdoor Unit Type
Humidifier
Dehumidifier
Outdoor Unit Type
Select one
Not Installed
2 Stage A/C Unit
2 Stage HP Unit 3a
save
3b
®
iComfort Wi-Fi
press 'about' for
more information on
a highlighted device
back
Add or Remove
1
yes
Non-communicating
equipment?
to add/remove/adjust a device,
select it, then press edit
current value:
Not Installed
2a
back next
2b
edit
non-communicating device list
back
1 Stage A/C Unit
Outdoor Unit Type
Outdoor Unit Capacity
1 Stage HP Unit
Humidifier
Dehumidifier
cancel
9:39 am Aug 15, 2012
Figure 6. Add Non-Communicating Device — Outdoor Unit
device feature list
Language Support
about
Equipment Type Name
Unit Model Number
Unit Serial Number
Unit Nominal Capacity
Number of Heating Stages
Heating Capacity by Stage
Indoor Blower CFM Range
next
Control Software Revision
Control Model Number
To add (or remove) an outdoor unit that is not iComfort
must be at the "Add or Remove Non-communicating equip­
ment?" screen.
1. Press the yes button on this screen (see 1).
2. In the non-communicating device list screen, use the
arrows (2a) to highlight Outdoor Unit Type and press
edit (2b).
3. Touch one of the radio buttons (3a) to select a 1-or
2-Stage AC Unit or a 1-or 2-Stage HP Unit; press save
(3b).
4. Use arrows (4a) to highlight any red colored text in the
device list (e.g. select Outdoor Unit Capacity; text turns
white). Press edit (4b).
5. Use arrows (5a) to make changes; press save (5b).
Change other red settings (if present) using a similar
process.
NOTE - If the defaults are correct, you do not have to make
any changes, but you must press save (5b). When all red text
is gone, the back button will appear; press it to return to the
Add or Remove Non-communicating equipment screen (1).
to add/remove/adjust a device,
select it, then press edit
current value:
2 Stage AC Unit
4a
please view and save all
red settings
back
7-Day Programmable Communicating Thermostat
Page 5
device description
Furnace
Equipment Type Name
Furnace
(returns to
system
devices
screen)
back
Outdoor Unit Capacity
Range is 18 to 60
edit
Default is 60 kBTU inc: 1
4b
set-to
60 kBTU
save cancel
5b
®
you
5a